BiXBiT Firmware for ASIC Whatsminer M3x Series With Additional Power Supply

Downlaod the BiXBiT custom firmware for Whatsminer M3x series, which is designed for Whatsminer M30, Whatsminer M31, and Whatsminer M32 with an additional power supply.

With an additional power supply, custom firmware for the Whatsminer M3x series allows for a 50% increase in overclocking of the ASIC models M30, M31, and M32.

  • Overclocking devices by changing frequency, voltage and consumption settings
  • Possibility to use an additional power supply and increase performance by 50%.
  • Possibility to use in immersion cooling mode

Get more Whatsminer firmware.

Installation Manual

  • Download firmware BiXBiT_Add PSU for M3x series
    Use WhatsMinerTool for the installation

    If the firmware can not be installed via WhatsMinerTool, you need to flash the ASIC via the SD card, as shown in the video.
  • The ASIC should be connected to a second power source. The detailed process is shown in the video below:
  • Once the firmware is installed, open the ASIC’s web panel and go to the Configuration>Miner Configuration>Overclock. Here are the locations of your ASIC’s configuration settings.

    This section also has the Immersion Cooling option, which has to be checked if you immerse the ASIC into liquid. If there are errors related to the PSU cooler, it is required to flash the PSU using the function in the firmware: Upgrade PSU Firmware under Configuration > Miner Configuration > PSU Firmware.


Does the ASIC Lose Its Warranty from the Manufacturer When Used With a Custom Firmware?

No clear answer exists. Please make use of the manufacturer’s firmware to prevent warranty problems.

Is Using a Custom ASIC Firmware from BiXBiT Free?

Free distribution is offered for the BiXbiT Whatsminer Firmware. Please be aware that custom firmware includes Developers Fee, which is a compensation for developers. The amount that is typically automatically subtracted from the miner’s total hashrate while the device is at work ranges from 1.8% to 2.8%.

Why the ASIC Does Not Start After Selecting a Profile?

The inbuilt algorithm may take up to an hour to finish configuring your ASIC, if you mean the first run after flashing the device.

Is It Risky to Use the Custom Firmware for ASIC from BiXBiT?

No, all firmware revisions are rigorously tested before each release. Furthermore, these firmwares have long been used by all BiXBiT capacities.

Is It Possible to Revert the ASIC Back to Its Original Settings After Using a Custom Firmware?

Yes, simply reinstall the official firmware using the standard procedure.

How to Bypass the “Cannot Find Signature” Message During the Flashing Process of the ASIC?

For instructions on how to fix this error when it occurs, consult the user manual for the particular miner version you are using.

Scroll to Top